To enhance heat transfer from a silicon chip, a copper pin fin is brazed to the surface of the chip. The pin length and diameter are L = 12 mm and D = 2 mm, respectively, and atmospheric air at V = 10 m/s and T[infinity] = 300 K is in cross flow over the pin. The surface of the chip, and hence the base of the pin, are maintained at a temperature of Tb = 350 K. (a) Assuming the chip to have a negligible effect on flow over the pin, what is the average convection coefficient for the surface of the pin? (b) Neglecting radiation and assuming the convection coefficient at the pin tip to equal that calculated in part (a), determine the pin heat transfer rate. (c) Plot the effect of increasing velocity (10 ≤ V ≤ 40 m/s) and on the total rate of heat transfer from the chip. (d) Calculate the drag force of the cylinder.

The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object

Tom is having a problem with his washing machine. he notices that the machine vibrates violently at a frequency of 1500 rpm due to an unknown rotating unbalance. the machine is mounted on 4 springs each having a stiffness of 10 kn/m. tom wishes to add an undamped vibration absorber attached by a spring under the machine the machine working frequency ranges between 800 rpm to 2000 rpm and its total mass while loaded is assumed to be 80 kg a) what should be the mass of the absorber added to the machine so that the natural frequency falls outside the working range? b) after a first trial of an absorber using a mass of 35 kg, the amplitude of the oscillation was found to be 10 cm. what is the value of the rotating unbalance? c) using me-3.5 kg. m, find the optimal absorber (by minimizing its mass). what would be the amplitude of the oscillation of the absorber?

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)