subject
Engineering, 15.04.2020 23:37 brianrodriguez2005

For a continuous fiber composite composed of 50 vol. % fiber, use the provided data to answer the following questions. Fiber: E_f1=220 GPa, E_f2=14 GPa and E_m=4.0 GPa. If a 40,000 N load is applied in the longitudinal direction of the fiber composite for a specimen of uniform cross section, estimate what percentage of the load is carried by the fiber. (Assume the load is within the L-E region of the composite.) If the composite ply were poorly generated resulting in little or no bonding between the matrix and reinforcing fiber, estimate (without calculation) what percentage of the load would is carried by the fiber in the longitudinal direction and briefly explain your reasoning. Calculate the modulus ratio (E_1/E_2) for the composite ply. Data for the components used to produce a uniaxial continuous fiber composite containing V_f=0.53 E-glass fiber embedded in epoxy are shown in the table below.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, colin774
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
image
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
image
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
For a continuous fiber composite composed of 50 vol. % fiber, use the provided data to answer the fo...

Questions in other subjects:

Konu
Mathematics, 26.08.2019 15:50
Konu
Mathematics, 26.08.2019 15:50