Engineering, 15.04.2020 21:52 Kalamazoo4750
The correct statement about the relation between the shear stress (force) at the surface for laminar and turbulent flow over a flat plate is. a. The laminar shear stress is greater because the fluid viscosity is not important in turbulent flow. b. The turbulent shear stress is greater because the mixing dissipates more energy, producing a greater stress at the wall. c. The laminar and turbulent shear stresses are equal at the same position (x) along the plate, but since turbulence occurs farther down the plate it produces a higher shear stress. d. The laminar shear stress is less because the boundary is thinner in the laminar regime.
Answers: 1
Engineering, 03.07.2019 15:10, breannaasmith1122
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10, demarcuswiseman
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 19:10, kayleeemerson77
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
The correct statement about the relation between the shear stress (force) at the surface for laminar...
Chemistry, 07.01.2021 21:50
Biology, 07.01.2021 21:50
Chemistry, 07.01.2021 21:50
Physics, 07.01.2021 21:50
Mathematics, 07.01.2021 21:50
Mathematics, 07.01.2021 21:50