Engineering, 15.04.2020 18:26 jespinozagarcia805

Which part of the result block should you evaluate to determine the Needs Met rating for that result?1.You always need to evaluate both the block and the landing page. a.True b. False2.For a Special Content Result Block, you only need to evaluate the content inside the block and nothing else. a.True b. False3.For a Web Search Result Block, in most cases you should evaluate just the content inside the block. a.True b. False4.For a Special Content Result Block, evaluate the content inside the block. You may also need to evaluate the landing page as well in some cases. a.Trueb. False

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

You know the right answer?

Which part of the result block should you evaluate to determine the Needs Met rating for that result...