Engineering, 15.04.2020 04:50 babyquinnz
You have designed a ductile hot-rolled steel bar that has yield strength in tension and compression of 400 MPa. Using the distortion energy theory. Maximum shear stress theory, and Maximum normal stress theory define the Factor of safety for the following three scenarios.
Scenario one: Plane stress where the principle stresses are σA=100 MPa and σB=50 MPa.
Scenario two: Plane stress where the principle stresses are σA=-50 MPa and σB=50 MPa.
Scenario three: The dimensional stress where σx=150 MPa and σy=0 MPa and Txx=100 MPa and the other stresses are zero.
Answers: 2
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
You have designed a ductile hot-rolled steel bar that has yield strength in tension and compression...
History, 21.01.2021 04:30
Mathematics, 21.01.2021 04:30
Mathematics, 21.01.2021 04:30