subject
Engineering, 15.04.2020 03:51 TrapQueen665

Part (IV) Following sketch show a proposed retaining construction project. Please do the
following:
2) Find factor of safety against sliding and overturning (F. S. > 1.5), perform eccentricity (middle third rule, e < ± B/6), check for qmax (qmax < Allowable bearing capacity) and qmin (No tensile stresses). If the wall is unsafe change the dimensions of slab and/or wall/construct key at base. Use the trial and error method to make sure all the safety checks are performed, and wall is safe. The soil above base slab (shown as shaded part) can be considered while performing the checks. There is no passive fill on other side.


Part (IV) Following sketch show a proposed retaining construction project. Please do the following:

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
image
Engineering, 04.07.2019 18:10, winterblanco
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
image
Engineering, 04.07.2019 18:10, aaliyah80
The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false
Answers: 1
You know the right answer?
Part (IV) Following sketch show a proposed retaining construction project. Please do the
follo...

Questions in other subjects:

Konu
Advanced Placement (AP), 02.09.2019 21:30