Engineering, 15.04.2020 03:14 d0ram0UsE
Consider a 7-truss structure. The cross-section area of all horizontal and vertical trusses is 3 inch^2, while the diagonal trusses have a cross sectional area of 1 inch^2. The truss structure is steel (modulus is 30 Msi). All horizontal and vertical truss members are 5 ft in length. Determine the maximum load P such that the highest stressed bar does not exceed t
Answers: 1
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Consider a 7-truss structure. The cross-section area of all horizontal and vertical trusses is 3 inc...
Mathematics, 26.11.2021 21:20
Social Studies, 26.11.2021 21:20
Biology, 26.11.2021 21:20
Social Studies, 26.11.2021 21:20