Engineering, 15.04.2020 00:56 walfrerr

1. Think about what you’ve learned about BJTs, both from lecture and from lab. What aspects of the transfer functions of the CE amplifier and the emitter follower can you sketch on your own (i. e. without having the PSpice simulation or Labview measurement)? What value does PSpice add to your ability to analyze these circuits?

Answers: 1

Show answers

Answers

Answer from: gisellekatherine1

Check all the explanations below. Also check all the attached files for additional information

Explanation:

A Bipolar Junction Transistor is a semiconductor device consisting of two P-N Junctions connecting three terminals called the Base, Emitter and Collector terminals. The current and the gain of theses transistors is determined by the arrangement of these terminals. The BJT uses both electrons and holes as the charge carriers. The BJT can be of two types, the PNP and the NPN transistors.

The common emitter amplifier is a three basic single-stage bipolar junction transistor and is used as a voltage amplifier. In this configuration, the emitter terminal is common to both the collector and the base, the input to the amplifier is taken from the base while the output is taken from the collector.

The common emitter amplifier circuit is attached as a file to this solution.

The current gain of a common emitter amplifier is $\beta = \frac{\triangle I_{c} }{\triangle I_{B} }$

where $I_{c} and I_{B}$ are the collector and emitter currents respectively

The voltage gain of the amplifier is given by $A_{v} = \beta \frac{R_{c} }{R_{B} }$

$R_{c} and R_{B}$ are the collector and base resistance respectively

In an emitter follower configuration, emitter follows the voltage on the base. It is also called the common collector configuration. The collector is common to the emitter and base terminals.

The common collector configuration is shown in the second file attached

The output voltage on a common-collector amplifier will be in phase with the input voltage, making the common-collector a non-inverting amplifier circuit.

The current gain = $\beta + 1$

Voltage gain = 1 ( Approximately)

Pspice helps in the simulation and analysis of electronic and electrical circuits without going through the rigors of using a pen and paper. It also allows us to test with real data and make proper choice of values.

1. Think about what you’ve learned about BJTs, both from lecture and from lab. What aspects of the t

Answer from: Quest

Wlficbs dkv she can ekeceiwnenfkvfeb

Answer from: Quest

Jkdjebekhrowhrvwkjrir is the season for the

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, aliopqwas

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

continue

You know the right answer?

1. Think about what you’ve learned about BJTs, both from lecture and from lab. What aspects of the t...