Engineering, 15.04.2020 01:03 jacobp0712

Consider a 150 kW, 30 m diameter horizontal axis, fixed speed wind turbine operating in a wind speed of 9 m/s. Two blades mounted on a cast iron hub drive a generator through a gearbox with a shaft speed ratio of 1: 50. If the speed of the shaft rotates at a rate of 45 rpm, calculate the power coefficient, the rotor tip speed and the torque on the generator shaft after c

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, nandalabella06

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

You know the right answer?

Consider a 150 kW, 30 m diameter horizontal axis, fixed speed wind turbine operating in a wind speed...