subject
Engineering, 14.04.2020 22:50 epicsushiman1

Problem 3 (15 points): An MOS capacitor is made from a 200 nm thick layer of silicon dioxide. The work functions of the metal and the semiconductor are the same. After specialized radiation treatment, the oxide layer traps charge with a surface concentration of OT = 4 × 10−9 C/cm2 . Calculate the effect of these trapped charges on the flat band voltage (VFB) of the MOS capacitor if the charge distribution in the oxide depends on the position linearly, starting from 0 C/ cm3 at the metal-oxide surface and increasing to 0.0004 C/ cm3 at the oxidesemiconductor surface. Give your answer in volts.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, theamandawhite
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
image
Engineering, 04.07.2019 18:10, dval1146
You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?
Answers: 1
You know the right answer?
Problem 3 (15 points): An MOS capacitor is made from a 200 nm thick layer of silicon dioxide. The wo...

Questions in other subjects:

Konu
Mathematics, 08.03.2021 22:40