Engineering, 11.04.2020 01:34 ADKREBS

18-09
A- CHECK A (W6x9) STEEL SECTION FOR
COLUMNS OF THE STRUCTURE SHOWN.
K=1.0
Worc =1.5K/F
d=5 7/8"
(W12x26) BEAM
(W6x9) COL. (W6x9) COL
-FINISH FLOOR
---
W6x9
A = 2.68 in2
rx= 2.41 in
ry= 0.905 in
B-CAN COLUMNS BE REPLACED WITH A (6x6 D. F. #1)
WOOD SECTION?

18-09 A- CHECK A (W6x9) STEEL SECTION FOR COLUMNS OF THE STRUCTURE SHOWN. K=1.0 Worc =1.5K/F d=5 7/8

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

Engineering, 04.07.2019 18:20, 21megoplin

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

continue

You know the right answer?

18-09
A- CHECK A (W6x9) STEEL SECTION FOR
COLUMNS OF THE STRUCTURE SHOWN.
K=1.0