Engineering, 10.04.2020 22:57 Nyasiabaltimore3
Forced air at 25C and 10m/s is used to cool chips on a circuit board. Consider a chip, 4mm x 4mm, located 120mm from the leading edge of the board. An empirical correlation has been established for the local Nusselt number:
Nu_x = 0.04 * Re_x^0.85 * Pr^(1/3)
Estimate the surface temperature of the chip if it is dissipating 30mW.
(Thermophysical properties of air at 25C are needed to solve this problem. Please state your reference source for this information.)
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:20, alexis9263
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20, krojas015
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
You know the right answer?
Forced air at 25C and 10m/s is used to cool chips on a circuit board. Consider a chip, 4mm x 4mm, lo...
Questions in other subjects:
English, 17.01.2022 03:40
Chemistry, 17.01.2022 03:40
World Languages, 17.01.2022 03:40
English, 17.01.2022 03:40
