subject
Engineering, 10.04.2020 20:22 simoncastro1

HELE
ou
ET
FEE
.
==
=
=
==
===
=
==
=
=
=
o esta a
EHET
TE
==
PS
TETE
FEE
=
Demand
Homme
e
LE
TEL
WWW.
ELS
S
10
15
20 25 30 35 40 45 50Duantity
A
L
AMALARARASI
ilin
0474
4342
ELIF E
T
lililililililili
BEBE
la
ile
SCALE
im
ELELE EIE
ALLEE

II
l
I
HERE
ELEET
Tallinn
e
Elie
ill
it
SLEE
The graph above shows one store's projected demand curve for hand-held vacuum cleaners. If the demand at point P3 is fully
satisfied, how much money will the store make by selling hand-held vacuum cleaners?
a. $900
b. $600
c. $400
d. $270

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, BardiFan
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:10, genyjoannerubiera
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
HELE
ou
ET
FEE
.
==
=
=
==
===
=
==
=

Questions in other subjects:

Konu
Mathematics, 09.04.2021 20:20
Konu
Mathematics, 09.04.2021 20:20
Konu
Chemistry, 09.04.2021 20:20
Konu
Social Studies, 09.04.2021 20:20