subject
Engineering, 10.04.2020 17:49 12bluestone

A vapor mixture contains benzene (C6H6) and 10.0 mole% toluene (C7H8) at 110°C and 1.00 atm. A continuous stream of this vapor mixture enters a separator at 15.0 mol/hr. The streams exiting the separator are at a dew point (90°C and 1.25 atm). The liquid and vapor leaving the separator can be considered in equilibrium. The vapor leaving the separator is then heated isobarically to 130°C.(a) Draw a process flow diagram, number the streams, and label the phase of each stream (solid, liquid, gas).(b) Calculate the flow rate (mol/hr) and mole fractions of the liquid that exits the separator.(c) Calculate the volumetric flow rate (m3/hr) at standard temperature and pressure (STP) conditions of the vapor stream that exits the heater.(d) An alternative solution could use the dew point pressure form of Raoult's law. Derive the expression for the vapor mole fraction of exiting benzene, and check the answer with the previous solution.(e) The separator breaks down making the process isobaric. Will the benzene composition of the liquid leaving the separtor increase, decrease, or stay the same?

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:20, 1230bering
Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives
Answers: 2
image
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
image
Engineering, 06.07.2019 03:10, kturvey225
Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window
Answers: 3
You know the right answer?
A vapor mixture contains benzene (C6H6) and 10.0 mole% toluene (C7H8) at 110°C and 1.00 atm. A conti...

Questions in other subjects:

Konu
Mathematics, 30.01.2021 09:10
Konu
History, 30.01.2021 09:10
Konu
Chemistry, 30.01.2021 09:20