Engineering, 08.04.2020 03:11 tmax8437
A square‐threaded power screw with single thread is used to raise a load of 25,000 lb. The screw has a mean diameter of 1 in. and four threads per inch. The collar mean diameter is 1.5 in. The coefficient of friction is estimated as 0.1 for both the thread and the collar. What is the major diameter of the screw? Estimate the screw torque required to raise the load. If collar friction is eliminated, what minimum value of thread coefficient of friction is needed to prevent the screw from overhauling? Ans.: (a) 1.125 in., (b) 4138 lb ⋅ in. , (c) 0.08
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, agpraga23ovv65c
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20, xcapo1x
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
A square‐threaded power screw with single thread is used to raise a load of 25,000 lb. The screw has...
Questions in other subjects:
History, 20.07.2019 23:40
English, 20.07.2019 23:40
