subject
Engineering, 07.04.2020 20:31 marleas

Cruiser A was traveling east at 60 mi/h on a police emergency call when it was hit at an intersection by car B, which was traveling south at high speed. After sliding together on the wet pavement, the two cars hit cruiser C, which was traveling north at 45 mi/h and was 63 ft from the intersection at the time of the first collision. Stuck together, the three cars hit a wall and came to a stop at D. Knowing that car B weighs 3600 lb and that each of the cruisers weighs 3000 lb, solve the problems below neglecting the forces exerted on the cars by the wet pavement and treating the cars as point masses. Knowing that the coordinates of point D are D x = 42 ft and D y = 46.5 ft, determine (a) the time elapsed from the first collision to the stop at D, (b) the speed of car B.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, BardiFan
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
image
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Cruiser A was traveling east at 60 mi/h on a police emergency call when it was hit at an intersectio...

Questions in other subjects:

Konu
Mathematics, 14.04.2020 03:08