Design a plate and frame heat exchanger for the following problem: Hot water at 0.0063 m3/s, 82.2°C, enters a plate and frame heat exchanger and is cooled to 57.2°C. Cold water enters this same exchanger at 0.00756 m3/s, 37.8°C. The plates are made of stainless steel (316SS) with a heat transfer

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?