Engineering, 07.04.2020 17:22 idklol81

Three phase, 12 pole induction motor is excited by 60 Hz three phase source. At rated load and speed, the induction motor runs at 860 rpm and absorb 90kW power from the three phase AC input. The kinetic energy of all revolving parts is 100kJ at rated load and speed. 1. Calculate the slip of the motor at rated speed. 2. If the voltage induced at rotor bar is 10V when the rotor is locked, what is the voltage induced at rotor bar when the motor is at rated speed? 3. What is the I^2R loss at rated load and speed? 4. Plugging is applied to stop the induction motor and then reverse the rotation to 860 rpm, how much power dissipated in the rotor circuit during this process?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

Engineering, 06.07.2019 03:10, tyheath42

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k, p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

continue

You know the right answer?

Three phase, 12 pole induction motor is excited by 60 Hz three phase source. At rated load and speed...