Engineering, 07.04.2020 16:57 binu

A shaft is loaded in bending and torsion such that Ma = 70 N. m, Ta=45 N. m, Mm=55 N. m, and Tm = 35 N. m. For the shaft, Su = 700 MPa and Sy=560 MPa, and a fully corrected endurance limit of Se=210 MPa is assumed. Let Kf=2.2 and Kfs=1.8. With a design factor of 2.0 determine the minimum acceptable diameter of the shaft using the

(a) DE-Gerber criterion.
(b) DE-ASME Elliptic criterion.
(C) DE-Soderberg criterion.
(d) DE-Goodman criterion.

Discuss and compare the results.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 19:10, Mimidj9279

The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false

Answers: 2

continue

You know the right answer?

A shaft is loaded in bending and torsion such that Ma = 70 N. m, Ta=45 N. m, Mm=55 N. m, and Tm = 35...