Engineering, 07.04.2020 02:20 karenpazyuli

Air at 22 kPa, 220 K, and 250 m/s enters a turbojet engine in flight at an altitude of 10000m. The pressure ratio across the compressor is 12. Turbine inlet temperature is 1400K, and the pressure at the nozzle exit is 22 kPa. The compressor and turbine have isentropic efficiencies of 85% and 88% respectively, and there is no significant drop in pressure for flow through the combustor. On the bases of air standard analysis considering the variation of specific heats, determine: pressures and temperatures at each principle state, and the velocity at the nozzle exit.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 18:20, annette211pdd8v9

For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.

Answers: 1

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 04.07.2019 19:10, nbunny7208

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces. a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

continue

You know the right answer?

Air at 22 kPa, 220 K, and 250 m/s enters a turbojet engine in flight at an altitude of 10000m. The p...