subject
Engineering, 07.04.2020 00:22 lukaslinder3529

Overview: In this scenario, you have been asked by the HR department of a small regional hospital to provide IT support for one of the intake clerks. She has always been considered a stellar employee but is returning to work after an extended illness. She has residual physical disabilities as a result of the illness, including weakness on her left side and lingering sight issues that cannot be fully corrected with glasses or contact lenses.

Prompt: Prepare a report that summarizes your recommendations for reasonable IT accommodations that will allow the employee to continue her work as an intake clerk

Specifically, the following critical elements must be addressed:

Technology Recommendations. What supporting technology (hardware or software) would you recommend to accommodate the clerk's disability? If multiple options are feasible, provide a summary of the pros and cons of each option, along with your final recommendation. Explain your rationale, focusing on cost, ease of use, and effectiveness
Work Environment Recommendations. What alterations to the work environment would you recommend? Consider the work station, ergonomics, and other relevant work-space characteristics.
Training and Support Recommendations. What training or other support resources would you recommend for the clerk as she returns to work? Be sure to identify services needed to effectively use identified software or hardware.

Guidelines for Submission: The report should be submitted as a two-to four-page Roman font, one-inch margins, and APA style for any citations. ord document that uses doube spacing, 12-point Times-e.

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, niyawilliams23
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
image
Engineering, 04.07.2019 18:10, colin774
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
image
Engineering, 04.07.2019 18:10, chadatkin
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
You know the right answer?
Overview: In this scenario, you have been asked by the HR department of a small regional hospital to...

Questions in other subjects: