Engineering, 06.04.2020 19:28 tohanab

To determine the appropriate landing speed of an airplane, the formula D = 0.10x2 – 3.00x + 22.0 is used, where x is the initial landing speed in feet per second and D is the distance needed in feet. If the landing speed is too fast, the pilot may run out of runway; if the speed is too slow, the plane may stall. What is the appropriate landing speed if the runway is 1019.50 feet long? Round your answer to the nearest whole number XXX

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, winterblanco

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:20, Doogsterr

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

You know the right answer?

To determine the appropriate landing speed of an airplane, the formula D = 0.10x2 – 3.00x + 22.0 is...