Engineering, 06.04.2020 19:02 lilquongohard

1. Objective (using ASSEMBLY in Raspberry pi)Developing a simple GCC assembly code for an ARM CPU. Practicing the use of various instructions and addressing modes. Implementing array related computations and program loops. Implementing Bubble Sort.2. TasksWrite a program that will first copy the contents of an array into a second array and then sort the second array in an ascending order. For the sorted array, the algorithm will find the minimum and maximum value as the first and last element in the sorted array, respectively. Finally, the algorithm will calculate the mean of squares of the values in the sorted array. The program requirements and implementation guidelines are provided below. Set Up the .data Segment:In the .data segment, declare an array of words starting at the label arr that will contain 32 elements with alternating signs: 1, -2, 3, -4â¦-29, -30, 31, -32.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 19:20, rida10309

At steady state, air at 200 kpa, 325 k, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross-sectional areas. the inlet cross-sectional area is 6 cm2. at the duct exit, the pressure of the air is 100 kpa and the velocity is 250 m/s. neglecting potential energy effects and modeling air as an 1.008 kj/kg k, determine ideal gas with constant cp = (a) the velocity of the air at the inlet, in m/s. (b) the temperature of the air at the exit, in k. (c) the exit cross-sectional area, in cm2

Answers: 2

continue

Engineering, 04.07.2019 19:20, GusGus11

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

You know the right answer?

1. Objective (using ASSEMBLY in Raspberry pi)Developing a simple GCC assembly code for an ARM CPU. P...