Engineering, 04.04.2020 02:02 885122bah

G Calculate the following for the shaft and the hole given below (dimensions in inches): (a) Tolerance on the shaft (b) Tolerance on the hole (c) Allowance (minimum clearance) (d) Maximum clearance (e) Type of fit

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 19:20, praveen35301

Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer

Answers: 1

continue

Engineering, 06.07.2019 03:30, neariah24

Give three differences between corrosion of metals and the corrosion of ceramics? what is static fatigue?

Answers: 1

continue

You know the right answer?

G Calculate the following for the shaft and the hole given below (dimensions in inches): (a) Toleran...