Engineering, 04.04.2020 00:04 danidavis2002

If the number of teeth in the gears 1 and 2 are 60 and 40, the module pitch =3 mm, the pressure angle 200 and the addendum = 0.318 of circular pitch determine the velocity of sliding when the contact is at the tip of the tooth of gear 2 and the gear 2 rotates at 800 rpm

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, brooklyn674

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:10, colin774

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

You know the right answer?

If the number of teeth in the gears 1 and 2 are 60 and 40, the module pitch =3 mm, the pressure angl...