Engineering, 03.04.2020 04:15 aidanfbussiness

Forced air at T= 25ºC and V= 12 m/s is used to cool electronic elements on a circuit board. One such element is a chip, 4 mm ×4 mm, located 120 mm from the leading edge of the board. Experiments have revealed that flow over the board is disturbed by the elements and that convection heat transfer is correlated by an expression of the form Nµx= 0.04 Rex^0.85. Pr^1/3. Required:Estimate the surface temperature of the chip if it is dissipating 30 mW.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jadeochoa4466

The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false

Answers: 2

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

You know the right answer?

Forced air at T= 25ºC and V= 12 m/s is used to cool electronic elements on a circuit board. One such...