Engineering, 01.04.2020 16:56 honeylebling

In a manufacturing process, long aluminum rods of square cross section with d = 25 mm are cooled from an initial temperature of Ti = 400°C. Which configuration in the sketch should be used to minimize the time needed for the rods to reach a safe‐to‐handle temperature of 60°C when exposed to air in cross flow at V = 8 m/s, T[infinity] = 30°C? What is the required cooling time for the preferred configuration? The emissivity of the rods is ε = 0.10 and the surroundings temperature is Tsur = 20°C.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, 19deleonl

Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 18:20, cxttiemsp021

Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.

Answers: 3

continue

You know the right answer?

In a manufacturing process, long aluminum rods of square cross section with d = 25 mm are cooled fro...