subject
Engineering, 31.03.2020 21:47 jetblackcap

A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facility can supply up to 10 Mgal/day of additional water with a BOD of 50mg/L, and a local stream can supply an additional 2 Mgal/day with a BOD of 200 mg/L. After use, the factory discharges the water is used to a local river. The concentration of biochemical oxygen demand (BOD) in the wastewater released to a nearby river must be less than 100mg/L. The cost of water is $1000/Mgal from the water supply facility and $150/Mgal from the local stream. The factory has obtained financing that allows them to spend no more than $3500/day on water.
a. Formulate a systems model and find the minimum cost solution that satisfies all constraints.
b. Then, reformulate the model for minimum discharge BOD solution that satisfies all constraints.
c. Plot the two solutions to the previous problem on a graph that has cost on the horizontal axis and BOD on the vertical axis. Draw a line connecting these two different optima and determine the slope of that line.
d. Propose a new environmental policy that would cause a profit-maximizing factory manager to put in place the BOD-minimizing design.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, brooklyn674
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
image
Engineering, 04.07.2019 18:10, abdirahmansoloman
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
image
Engineering, 04.07.2019 18:10, alyssabailey7545
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
image
Engineering, 04.07.2019 18:10, soreese02
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
You know the right answer?
A factory requires at least 4 Mgal/day more water than it is currently using. A water supply facilit...

Questions in other subjects:

Konu
History, 23.10.2020 15:50