Engineering, 31.03.2020 17:29 LuxTheGirl3070

A. Find the current, I, required to establish a flux 0= 2.4x10-4 Wb in the
magnetic circuit of Figure. Here, Area(throughout) = 2x10-4 m², lab = Lef= 0.05 m
laf = lbe = 0.02m, lbc = ldc, and the material is sheet steel.
b. Compare the mmf drop across the air gap to that across the rest of the magnetic
magnetic
circuit. Discuss your results using the value of u for each material.
(NOTICE: find the magnetization curve in page 29 Figure 1.32 in Reference 00
Motor and controlling. The reluctance of sheet steel should be taken into
calculation)

A. Find the current, I, required to establish a flux 0= 2.4x10-4 Wb in the magnetic circuit of Figur

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

You know the right answer?

A. Find the current, I, required to establish a flux 0= 2.4x10-4 Wb in the
magnetic circuit of...