Engineering, 30.03.2020 17:35 daijahamaker062816
A round hole will be created at a sheet metal with a single punch. The diameter of the hole is 10 mm and the thickness of the sheet metal is 1 mm. The ultimate tensile strength of the material is 190 MPa.
Calculate the necessary force to cut the hole at the sheet metal.
Answers: 2
Engineering, 04.07.2019 18:20, yasyyas646646
Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.
Answers: 3
Engineering, 04.07.2019 18:20, rbgrh9465
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
Engineering, 04.07.2019 19:10, nayi2002
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
Engineering, 04.07.2019 19:20, qurreab26
A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.
Answers: 1
A round hole will be created at a sheet metal with a single punch. The diameter of the hole is 10 mm...
Mathematics, 18.03.2021 03:30
Chemistry, 18.03.2021 03:30
Mathematics, 18.03.2021 03:30
Health, 18.03.2021 03:30
Mathematics, 18.03.2021 03:30