Engineering, 27.03.2020 02:58 wutwut2261

A 3/8-16 UNC nut and bolt are used to assemble steel plates. The clearance holes in the plates are 7/16 in. The plates are clamped together by the nut and bolt with a force of 500 lb. If the torque coefficient is 0.22, determine the (a) torque that is applied and (b) resulting stress on the bolt

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 19:10, jrcspiderman2003

Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?

Answers: 3

continue

Engineering, 04.07.2019 19:20, molly7654

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

continue

You know the right answer?

A 3/8-16 UNC nut and bolt are used to assemble steel plates. The clearance holes in the plates are 7...