Engineering, 26.03.2020 20:02 8336622

14 (bonus). You have a material of a length of 10mm and a diameter of 0.2 mm. When you apply a tensile 4 force of 1.110 N, this material elongates to the length of 15mm. You measure a diameter of the elongated sample and you find that it is now 0.16 mm. Assuming the deformation remains elastic, calculate Poisson ratio and Young’s modulus of this material (in GPa)14 (bonus). You have a material of a length of 10mm and a diameter of 0.2 mm. When you apply a tensile 4 force of 1.110 N, this material elongates to the length of 15mm. You measure a diameter of the elongated sample and you find that it is now 0.16 mm. Assuming the deformation remains elastic, calculate Poisson ratio and Young’s modulus of this material (in GPa)

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

You know the right answer?

14 (bonus). You have a material of a length of 10mm and a diameter of 0.2 mm. When you apply a tensi...