Engineering, 25.03.2020 22:29 nestergurl101

A non-inverting amplifier has a feedback resistor of 10 kohms aAssuming rail-to-rail output voltage swing and TYPICAL output current limit as specified in the op-amp datasheet, what will be the output voltage when a 4V input signal is applied to the circuitnd an input resistor of 5 kohms. It is connected to a load RL = 500 ohms. The amplifier is built using a LM741C op-amp powered from +12V and -8V supplies.

what will be the output voltage when a 4V input signal is applied to the circuit?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, dval1146

You are making beer. the first step is filling the glass carboy with the liquid wort. the internal diameter of the carboy is 15 in., and you wish to fill it up to a depth of 2 ft. if your wort is drawn from the kettle using a siphon process that flows at 3 gpm, how long will it take to fill?

Answers: 1

continue

You know the right answer?

A non-inverting amplifier has a feedback resistor of 10 kohms aAssuming rail-to-rail output voltage...