Engineering, 24.03.2020 22:41 emmanuel96
You are taking a measurement of a signal from a sensor with high-frequency noise. In order to not amplify that noise through your instrumentation system, you decide to use an RC filter with a cutoff frequency (critical frequency, fc) of 1kHz after the sensor and before the amplification.
(a) What kind of RC filter do you need? Design the RC filter. Be sure to use standard resistor and capacitor values and specify the tolerance. Show all work.
(b) Construct the circuit using Multisim. Use the tolerances which you specified in your design.
Answers: 3
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 19:10, Lexi5170
A)-explain briefly the importance of standards in engineering design. b)- what is patent? c)-explain the relationship between these standards: b. s. and b. s.en d)- in engineering design concepts, types of loads and how they act are important factors. explain.
Answers: 3
You know the right answer?
You are taking a measurement of a signal from a sensor with high-frequency noise. In order to not am...
Questions in other subjects:
Geography, 21.02.2020 17:30
Biology, 21.02.2020 17:30
Physics, 21.02.2020 17:30
