Engineering, 18.03.2020 22:34 juliann9160
Air flows steadily between two sections in a long, straight portion of 10-cm inside diameter pipe. The uniformly distributed temperature and pressure at each section are given. The average air velocity at Sections (1) and (2) are 66 m/s and 300 m/s, respectively. Assume uniform velocity distributions. Determine the frictional force (Rx) exerted by the pipe wall on the airflow between the sections. At section (1), p1 = 7 MPa, T1 = 25°C, and V1 = 66 m/s. At section 2, p2 = 1.3 MPa, T1 = -20°C, and V2 = 300 m/s. (5 pt)
Answers: 2
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, oshawn108
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k
Answers: 2
Engineering, 04.07.2019 18:20, ashleyjaslin
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
Engineering, 04.07.2019 18:20, AnonymousLizard52303
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
Air flows steadily between two sections in a long, straight portion of 10-cm inside diameter pipe. T...
Questions in other subjects:
History, 01.10.2019 04:40
Chemistry, 01.10.2019 04:40
