Engineering, 17.03.2020 22:20 nadiamckinney

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a tensile test machine. The figure below shows the resulting Stress-Strain diagram. Use the information in the diagram to find the information below.

Calculate the elongation (δ) for this material using YP data:

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a ten

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, myahlit84

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

You know the right answer?

A test sample, with a cross-sectional area of 0.325 in2 and a 2.25” length, is pulled apart in a ten...