Engineering, 16.03.2020 21:29 Levantine2643

An engineer sets the pressure in a supply tank using a very accurate manometer as a guide and then reads the output of a 20-psig pressure gauge attached to the tank as 10.2psig. Sometime later she repeats the procedure and obtains values of 10.4 and 10.3 psig. Discuss the following gauge properties: (a) Precision (b) Accuracy (c) Resolution (d) Repeatability Express these answers on a percentage of full-scale basis.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

Engineering, 04.07.2019 18:20, hayleymckee

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

continue

You know the right answer?

An engineer sets the pressure in a supply tank using a very accurate manometer as a guide and then r...