Engineering, 13.03.2020 22:02 live4dramaoy0yf9

Design worksheet problem (2 points) - Create your own design calculator problem: You’re going to design a spring to be used in combination with a linear dashpot to form a ""shock absorber"". See figures below for the following terms. D refers to the mean coil diameter and d is the wire diameter. The ID of the spring should be greater than 1 inch so that you can slide the dashpot inside. The ""max loaded length"" in a dynamic scenario is 1.5 inches at 75 pounds and the free length is 3 inches. The spring has ground plane ends such that the solid height will be: = ( + 2). Assume that the Wahl factors are K = 1.15 and that you have to keep torsional stress below 100ksi

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 19:10, babas97

What is a monomer? how do they form a ploymer from the view point of chemical bonding?

Answers: 1

continue

You know the right answer?

Design worksheet problem (2 points) - Create your own design calculator problem: You’re going to des...