Engineering, 13.03.2020 16:52 claytonashley30

Circular fins of uniform cross section, with diameter of 10 mm and length of 50 mm, are attached to a wall with surface temperature of 350°C. The fins are made of material with thermal conductivity of 240 W/m·K, and they are exposed to an ambient air condition of 25°C and the convection heat transfer coefficient is 250 W/m2 ·K. Determine the heat transfer rate, fin effectiveness, fin efficiency, and plot on the same plot the temperature variation of a single fin for the following boundary conditions: a. Infinitely long fin b. Adiabatic fin tip c. Fin with tip temperature of 250°C d. Convection from the fin tip

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

You know the right answer?

Circular fins of uniform cross section, with diameter of 10 mm and length of 50 mm, are attached to...