Engineering, 12.03.2020 20:51 majestyic1207

Prepare a sketch, using ISA standard symbology for the following flow metering and control scenarios: The goal of this problem is to get your familiar with the different symbology in controls. a. orifice meter located on pipe A, independent P/I transducer, 4-20mAmp transmitter, independent field flow controller, independent 4-20 mAmp I/P transducer, pneumatically operated flow control valve located on pipe B b. venturi meter located on pipe A w/ digital output, independent field flow indicator, plus centralized indicator in DCS c. integrated mass flow controller w/ digital output located on pipe A plus centralized indicator in DCS d. orifice meter located on pipe A w/ digital output, fieldbus-compatible flow control valve located on pipe B plus centralized indicated in DCS

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

You know the right answer?

Prepare a sketch, using ISA standard symbology for the following flow metering and control scenarios...