Engineering, 12.03.2020 03:29 levon15

At the inlet to the combustor of a supersonic combustion ramjet (or scramjet), the flow Mach number is supersonic. For a fuel-air mass ratio of .03 and a combustor exit temperature of 4800 degr, calculate the inlet Mach number above which the flow will be unchoked. Assume one- dimensional frictionless flow with y = 1.4, with heat release per slug of fuel equal to 4.5 x 108 ft-lbf. (Anderson 3.11) The temperatures for the above combustion problems are pretty high. A more representative value of the heat capacity ratio for products of combustion at these temperatures is y = 1.28 The value of the specific gas constant R may still be approximated as equal to that of air. b) For problem #2, calculate the inlet Mach number above which the flow will be unchoked, based on y = 1.28

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 18:10, niyawilliams23

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

You know the right answer?

At the inlet to the combustor of a supersonic combustion ramjet (or scramjet), the flow Mach number...