Engineering, 12.03.2020 02:13 sherlock19

Sometimes, we need an amplifier with an accurate gain. Even using 1% tolerance resistors may not be sufficient to provide the required gain tolerance. In these designs, trimmer resistors must be used that can be adjusted after the circuit is built. Each resistor in the circuit can be replaced by a series combination of a fixed resistor and an adjustable resistor. Consider the inverting amplifier below with R1=47kΩ and R2=450kΩ. The source signal internal resistance varies from 0 to Rsmax=1kΩ. Only one trimmer resistor can be added, and it is going to be put in series with the feedback resistor. What are the lowest and highest values R must be able to have so that the gain can be adusted to Av=−10±0.5%? Assume that all resistors have 1% tolerance.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 18:10, selenamr

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

You know the right answer?

Sometimes, we need an amplifier with an accurate gain. Even using 1% tolerance resistors may not be...