subject
Engineering, 11.03.2020 05:28 powellkolbie

Design circuits that demonstrate all of the principles listed below. Set up the circuits and take measurements to show that the principle in question is indeed correct.

Principles of Series Circuits:
The voltages across each circuit element add to that of the battery.
The current through each circuit element is the same.
Higher resistances have higher voltage across them.
Resistors added in series to any circuit increase the resistance to current in the circuit.

Principles of Parallel Circuits:
Voltages across each circuit element are the same.
The current through each parallel circuit element adds to that going through the battery.
The higher resistance in a parallel circuit has less current.
Resistors added in parallel to any circuit reduce the resistance to current in the circuit.

General Principles:
A branch in a circuit that contains a short has no voltage across it.
A branch in a circuit that is open has all the voltage across it.
A battery is a constant voltage source.
A battery is not a constant current source.
Ammeters have very little internal resistance.
Voltmeters have very large internal resistance.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:10, mamasbug4285
An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0
Answers: 3
image
Engineering, 04.07.2019 18:20, ashleyjaslin
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
image
Engineering, 04.07.2019 18:20, rhussein6452
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
You know the right answer?
Design circuits that demonstrate all of the principles listed below. Set up the circuits and take me...

Questions in other subjects:

Konu
English, 09.07.2019 22:40