Engineering, 11.03.2020 05:27 sheyunicorn

Consider a N-channel enhancement MOSFET with VGS = 3V, Vt = 1 V, VDS = 10 V, and lambda =0 (channel length modulation parameter). Which of the following best describes the behavior of this transistor?a. The current IDS is greater than 0 since the VGS has induced an inversion layer and the transistor is operating in the triode region. A value of VDS=12 V would not result in a higher IDS current. b. The current IDS is greater than 0 since the VGS has induced an inversion layer and the transistor is operating in the saturation region. A value of VDS=12 V would result in higher IDS current. c. The current IDS is greater than 0 since the VGS has induced an inversion layer and the transistor is operating in the saturation region. A value of VDS=12 V would result in a higher IDS current due to channel-length modulation. d. The current IDS is greater than 0 since the VGS has induced an inversion layer and the transistor is operating in the saturation region. A value of VDS=12 V would not result in a higher IDS current.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

You know the right answer?

Consider a N-channel enhancement MOSFET with VGS = 3V, Vt = 1 V, VDS = 10 V, and lambda =0 (channel...