subject
Engineering, 10.03.2020 07:24 migos0917

By the mid-1980s, the prices of economy cars had risen substantially, with the smaller Japanese and American sedans costing five figures or more.

2. Because of import quotas, the Japanese could export only a limited number of vehicles, and they preferred to ship their more profitable luxury lines to America.
3. American car companies claimed that the profit margins on cheap cars were too small to justify producing vehicles under $6,000.
4. As a consequence, a gap opened at the lower end of the automobile market, leaving room for manufacturers from Third World countries to compete.
5. They introduced to America some of the lowest-priced cars consumers had seen in years.

What is the correct organization pattern?

Classification and Partition
Cause and Effect
Comparisons
Spatial Organization
Chronological
Example
Problem-Methods-Solution
General to Specific
Specific to General
Order of Importance
Order the paragraph correctly.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
image
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
image
Engineering, 04.07.2019 18:10, Fahaddie
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
image
Engineering, 04.07.2019 18:10, caitlynnpatton1208
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
By the mid-1980s, the prices of economy cars had risen substantially, with the smaller Japanese and...

Questions in other subjects: