![subject](/tpl/images/cats/User.png)
Engineering, 07.03.2020 03:28 aidy7267
The ratio of the rate of etch-product formation to the flow rate of etch gas should be greater than 0.15 for uniform etching. Suppose a 200 mm diameter silicon wafer is etched at a rate of 50.0 nm/min in a CF4 plasma.(a) How many Si atoms are removed per minute?(b) What evolution rate of SiF4 does this correspond to in standard cubic centimeters per minute?(c) What minimum flow rate of CF4 should be maintained?
![ansver](/tpl/images/cats/User.png)
Answers: 2
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, tobyhollingsworth178
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
You know the right answer?
The ratio of the rate of etch-product formation to the flow rate of etch gas should be greater than...
Questions in other subjects:
![Konu](/tpl/images/cats/biologiya.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.04.2021 17:40
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/istoriya.png)
![Konu](/tpl/images/cats/en.png)
English, 23.04.2021 17:40
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.04.2021 17:50
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.04.2021 17:50