Engineering, 07.03.2020 02:59 pilararcos

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for the LED specifies that VF = 2 V. Treat LEDs as diodes with the constant voltage model. (a) Find the expected current through the LED I(LED) when VF = 2 V (b) After testing, it is determined that some LEDs within a batch do not light up correctly in the circuit for part a. It is suspected that this is because there is some variation in among the LEDs in the batch. Find the maximum value of VF such that the circuit above stops working I(LED) drops to zero so you can characterize this problem and report it to the manufacturer.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

You know the right answer?

Problem 4 You are designing a circuit to drive LED1, using the following circuit. The datasheet for...