Engineering, 07.03.2020 00:36 jilliandantuma84

A 0.5 in diameter rubber plug is placed inside a tube whose inside diameter is 0.57 in. The Modulus of Elasticity of the rubber plug is E = 730 psi and Poisson's ratio is ν = 0.45. If the tube and the plug are the same length, what pressure, p, must be applied to the rubber plug to cause it to contact the sides of the tube? Express your answer in psi, to the nearest psi.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, margaret1758

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:20, ashleyjaslin

Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.

Answers: 3

continue

You know the right answer?

A 0.5 in diameter rubber plug is placed inside a tube whose inside diameter is 0.57 in. The Modulus...