Engineering, 06.03.2020 23:38 naiomireyes74p2aybs

Four hundred grams of nitrogen gas (molecular weight = 28 g/mole) are stored in a 10-liter container. Set up an Excel worksheet to determine the pressure of the gas (in atmospheres) as a function of temperature and volume, assuming nitrogen is an ideal gas. Place the value of each variable in its own cell. Label all of the quantities clearly. Recall that the ideal gas law is PV=nRT where P = pressure (atmospheres) V = volume (liters) n = number of moles (mass of gas/molecular weight) R = ideal gas constant (0.082054 liter atm/mole K) T= absolute temperature (°K = °C + 273) (a) What pressure in atm corresponds to a temperature of 17.5°C?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

You know the right answer?

Four hundred grams of nitrogen gas (molecular weight = 28 g/mole) are stored in a 10-liter container...