subject
Engineering, 06.03.2020 21:48 theworld58

An Arnold cell is to be operated as a pseudo-steady-state cell to determine the gas diffusivity of benzene in air at 308 K and 1.0 atm. The 20-cm-long tube, with an inner diameter of 1.0 cm, is initially loaded with liquid benzene to a depth of 1.0 cm from the bottom of the tube. The tube and the liquid are maintained at a constant temperature of 308 K. At this temperature, benzene exerts a vapor pressure of 0.195 atm. Air is continually blown over the top of the tube, removing any of the vaporized benzene vapor; the gas space within the tube is essentially stagnant. At 308 K, liquid benzene’s density is 0:85 g/cm3.

a. It was determined that 72.0 h were required to completely evaporate the benzene initially loaded into the tube. Estimate the binary gas-phase diffusion coefficient for benzene in air using these data.

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, mm016281
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, namira16
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
You know the right answer?
An Arnold cell is to be operated as a pseudo-steady-state cell to determine the gas diffusivity of b...

Questions in other subjects:

Konu
Social Studies, 27.01.2020 17:31
Konu
Chemistry, 27.01.2020 17:31
Konu
Mathematics, 27.01.2020 17:31